VERSATints User Manual
Enter a versatile era of window tinting!
INSTALLATION VIDEO
INSTALLATION STEPS
* There is protective film on both sides of the tint
Thoroughly clean your window with soapy water and dry completely after cleaning with a lint-free towel.
Peel the first side of the tape and cut out thin adhesive strips from the included roll and affix them approximately ½ inch from the top edge of the glass. (see diagram)
* Ensure the window is rolled down around 3/4ths of the way to the top
Peel the adhesive backing from one side of your tint.
Carefully slide your VersaTints into the window seal and make sure your tint is aligned with the top of the glass.
Alternate Method: If you find it difficult - or if the tint is not sliding behind the window seal - lower the window to the bottom, which should provide you enough room to position the tint between the glass and the window seal mounted to the door. Insert the tint into the space such that the top of the tint is approximately 5 inches below the frame (or where the window would be fully extended). You should now be able to raise the window up behind the tint without difficulty.
Gently press your VersaTints against the adhesives on your glass.
Roll down your windows to ensure functionality.
To remove: Start at the top corner and give it a gentle pull!
To reapply: Just slide your VersaTints back in and make sure to adhere to the adhesives.
⚠️IMPORTANT NOTICE
For rear windows, we recommend lowering around any sensors or cameras to ensure proper fit. Simply use a cutting tool or scissors to trim your rear window film.
Created by VersaTints